Display Wall Cabinet Plans & Schematics For a Lovely Showcase

Display Wall Cabinet Plans Blueprints 00 Draft Design

Given below are some display wall cabinet plans and blueprints that will help you build a lovely showcase.

It can be placed on a table or wall-mounted.

It has tempered glass doors and three shelves, with a design that calls for all straight cuts and straightforward construction techniques.

The simple cut-outs give the effect of multiple panes of glass in the single-pane doors.

This project can be given a finish to match any decor.

The display cabinet measures about 32 inches wide by 22 inches tall by 9 inches deep, and the shelves are each about 7 inches deep.

Assembly Instructions

Display Wall Cabinet Plans Blueprints 03 Isometric View
Display Wall Cabinet Plans Blueprints 01 Bill Of Material
Display Wall Cabinet Plans Blueprints 02 Cutting Schedule

Use 1” nails and glue to attach boards H and I to boards A. Attach G to C and F to D in the same manner.

Refer to Figures 1 and 2 and isometric.

Use 1 1/2” finish nails and glue to attach boards C to E. Make sure that the boards line up square.

Refer to isometric and Figure 3 for location.

Use 1 1/2” finish nails and glue to attach boards B and D to E.

Use 1 1/2” finish nails and glue to attach boards A to B, C, D and E. Refer to Figures 1 and 2.

Drill a 3/8” hole in boards M and L for 1” dowel. Refer to Figures 4 and Drill a 3/8” hole is boards J and K.

Use 3/8” x 1” dowels and yellow glue to attach boards K to J. Use the same procedure for door frame.

Use 1 1/2” finish nails and glue to attach J and K to A, B and D. Refer to isometric.

Drill a large hole in one of the panels.

Use a jigsaw or scrollsaw to cut out the six openings in board N.

Display Wall Cabinet Plans Blueprints 04 Glass Panel
Display Wall Cabinet Plans Blueprints 05 Corner Details
Display Wall Cabinet Plans Blueprints 06 Nailing Pattern
Display Wall Cabinet Plans Blueprints 07 Dowel Rabbet
Display Wall Cabinet Plans Blueprints 08 Panel Cutting Pattern

Glue two O boards to the inside face of board J. Refer to Figure 6 and isometric.

Cut and attach molding P and Q. Use 1” finish nails and glue. Refer to Figure 2 and Isometric.

Cut a small gain in board L door frame to accommodate hinges. The depth of the gain will be determined by the size of the hinge and the amount of clearance around the door.

Rout a 3/8” x 5/16” deep rabbet on the inside edge of door L and M. Refer to Figures 4 and 5.

Apply finish at this time. Locate knobs in the middle of board L. Attach hinges and glass supports. Insert panel N and glass.

Attach two magnetic latches to board O for doors. Refer to Figures 4, 5 and 6.

close button